@george1421 said in Surface Pro 7:

@FOG-Summacom First lets get the FOS Linux kernel information. Second if needed there is an off-line method to update the kernel.

Hello George,

again, many thanks for your support.
I have entered the proxy data in the section Proxy Settings.
After some chances into our Firwall, know I can see the Kernel Updates. ^^

On next I klick on “Kernel - 5.6.18” and see following Screen:

I don’t know if I have to install the latest version now.
Is it possible to do an online update via the backend of the software?

The test Surface is at this time no longer in the company.
I will do another test as soon as possible.

Best Regards and an fine Weekend,
Ralf

@george1421 said in Surface Pro 7:

Understand until we get the kernel updated the network adapter won’t work.

You can “test” the updated kernel from the FOG Configuration -> Kernel Update menu. Version 5.6.18 of the kernel is the latest, but was just released this week. There may be a few bugs in it (should not be but its just so new to say for sure). You can try that kernel it has the latest linux drivers installed.

The Problem is, that the FOG server is not connected to the Internet and that is why I cannot see or use any other kernel.
Maybe the Proxy config is the key…

I asked my colleagues and Linux administrator to help me.

Best Regards,
Ralf

@george1421

Thanks again for your Feedback.
For Point 1b) the Hardwareinfo for Networkdevice called “VID_045E&PID_07C6”.

May be, i test the actual kernel… I’m not sure about my know how about this…

Best wishes,
Ralf

Hello George,

many thanks for your Feedback.

Now I’ve looking at ours FOG Version: “DefaultMember FOG Version: (1.5.5)”.
Used network adapter is from Microsoft-Dockingstation. I can’t see where the excact type is.

In the Link below to photo album are more screens and photos, hope you can see any more helpful data…

More Screens from the BIOS-Settings and from the Ethernet into Windows 10

What do you mean excact with “… look at the hardware ID for the network adapter”?

I’ve disable fast startup and use shutdown command…
I start again with pxe, but the same problem occurs after FOG-Menu starts and I chosse “Quick…” (see Photos in photo album).

I’ve make an driver update on Windows 10 for ethernet successfully. But it’s does’nt help.

Best regards,
Ralf

Hello everybody,

i’m new in this forum and i’m searching for topics about “Surface Pro 7”.
My Problem is, that i can’t perform Quick Registration.
I’m booting IPXE and entering the FOG-Menu, after selecting “Quick Registration…”, the process does’t ending successful.
Here Photos with Boot Messages and Errors

Is it possible to use FOG for imageing an Surface?

Many Thanks in advanced for useful feedback and best Regards,
Ralf