@george1421

here’s the screenshot with those commands

@george1421

ok I ran the following command nano /etc/resolv.conf but now I’m getting the this message: DO NOT EDIT THIS FILE BY HAND–YOUR CHANGES WILL BE OVERWRITTEN

@george1421
I’m sorry I don’t understand what your asking

@george1421

had to take a picture of the command because I could not access internet with FOG server. also could not PXE boot while connected to my router or on Isolated network using switch. thanks for your help

@george1421

if I could ask another question. If the FOG server is running DHCP and is plugged up to a switch without internet access, I should be able to PXE using a laptop plugged up the same switch?

@george1421

ok will do as soon I get home. would the command to retrieve the information be sudo or cat /etc/resolv.conf file?

@george1421

it’s not plugged up to isolated internet yet. Right now its plugged up to my router. everything was working fine until yesterday. then my another PC started using my FOG server as its DHCP server which caused all kinds of issue with my home network. Once I rebooted my router my issue was resolved with my home PC but now I can’t PXE boot to the FOG server or access the internet. I can ping 8.8.8.8 but can’t ping www.google.com any help would be great.

@george1421

ok thanks, During the install of FOG software I took the defaults so DNS and DHCP were installed. for some reason, the FOG server worked perfectly over the weekend but now I’m not able to PXE boot to the server and
I’m not to able to ping www.google.com but I can ping 8.8.8.8 so I guess this is a DNS issue. here the error message on the server . do you think removing DNS could fix the error message below

@george1421

all I need the fog server to do is upload an image and down an image using PXE boot. Can I get by without DNS and DHCP?

@george1421

Let me ask you one more question, it may even sound a little stupid, but if I take the Fog Server and plug it up to a hub then take the laptop I’m trying to PXE boot and plug it up to the hub also, without any internet going to the hub should it still be able to PXE boot?