Yes, I tried changing it between and it’s still the same. By the way, how exactly can I edit the initial setup settings? I found the the fogsettings file located in the fog user folder but I have no permission over it and don’t know the default password for it.
Are the settings in the web interface all there is? Because I tried there to change between eth0 and 1 but got nothing still.
Thanks.
C
Posts made by ciprian
-
RE: Trying to setup FOG to use one network card just for PXE boot and the other one for the internet interfaceposted in General
-
RE: Trying to setup FOG to use one network card just for PXE boot and the other one for the internet interfaceposted in General
The correct network interface is written there, eth0 which is the dedicated network card I chose for reimaging. That’s what doesn’t add up for me.
-
RE: Trying to setup FOG to use one network card just for PXE boot and the other one for the internet interfaceposted in General
Well I did a fresh install again and when the setup asked me which interface to use I wrote eth1 instead of eth0, I made sure eth1 is the dedicated network card for it but it isn’t working. I pluged the cable in the main interface I use for web and the PC boots through that one. Can’t I change them now somehow?
I appreciate your answer. -
Trying to setup FOG to use one network card just for PXE boot and the other one for the internet interfaceposted in General
Hello. I want to setup fog on a computer that has two ethernet adaptors. I want the web interface to be accessible through the network but I want FOG only to have access for PXE booting, reimaging through a different card that will be used on an isolated network. How can I set this up exactly? I got a little bit lost through the setup, I actually managed somehow but I think I changed some configuration afterwords and it stopped working.
Thank you in advance.