@Tom-Elliott It works!
But I get the message of the IP address of the interface eth0 repeated, as if IP search several times with the same itnerfaz.
Thanks a lot!
C
Posts made by ccrespi
-
RE: How to add bnx2x firmware to kernelposted in Hardware Compatibility
-
How to add bnx2x firmware to kernelposted in Hardware Compatibility
Hello!
I have a PC with a network card (Broadcom 57811) 10Gb fiber. When boot by network (BIOS legacy mode) (PXE filename: undionly.kkpxe) an error appears as it can not load the firmware bnx2x 7.13.1.0.fw. To solve it I have tried two options:
A: I downloaded the 4.11.6 kernel to compile it with this active module (make menuconfig> Broadcom support 587XX)) and an error appears with initram when booting. Using the init.xz file that comes with FOG by default.
B: I downloaded the 4.11.0 kernel and copied the configuration file from kitchensink.conf to .conf to compile it, adding the firmware file “bnx2x-e2-7.13.1.0.fw” to the firmware / bnx2x folder. When you boot it again the error appears that it can not load the firmware.
I have no experience with the Linux kernel or boot images initram.
How can I solve that?Thank you very much!
