Posts made by carmonj

Might be easier at this point to just do a complete re-install of the machine. I’m not sure why the partition table looks the way it does, but starting from scratch is sometimes the easiest bet.

This time I’ll start in the VM environment.

I set it to 130gb because that’s what I was told was on the machine for imaging. I’m going to increase the HDD size to 480 and see what happens. I may have to personally setup the imaging machine to make sure everything is setup properly.

The image type is set to Single disk resizeable.

dl.minimum.partitions

label: dos
label-id: 0x161519e0
device: /dev/sda
unit: sectors

/dev/sda1 : start= 2048, size= 201698708, type=7
/dev/sda2 : start= 976134144, size= 75826, type=7, bootable

dl.partitions

abel: dos
label-id: 0x161519e0
device: /dev/sda
unit: sectors

/dev/sda1 : start= 2048, size= 419430400, type=7
/dev/sda2 : start= 976134144, size= 75826, type=7, bootable

d1.fixed_size_partitions

:2

I am deploying again, but on my last attempt I did not see any errors.

Thank you for that tip. Turns out the imaging machine needed chkdsk /f ran on it. Now of course I am getting an error on image deploy.

w3

I will probably have to start a new thread.

Hello all,

I hae FOG Project 1.5.5 running, but when I do a capture on a Windows 7 box the capture process constantly restarts after getting to 100%. I do not see any errors in the log files. Any help would be appreciated.