Ended up being a database related error on the server. I basically went through the install of the server software again, then activated the “new” database and all good.

During image creation process the remote PC (being imaged) reboots about every 10 minutes. No progress on the image of writes to the data base. Any ideas? Don’t see any errors on the FOG system logs.

@sebastian-roth

I found a setting deep in the configuration options to increase the default value from what is was to 99.

What a great reply, it wasn’t the complete answer but caused me to look deeper into the DHCP server and configuration. The PXE options has been set in the master scope section of the server. However, I entered the settings into the action scope for the V-Lan I was looking to boot from.

Now the endpoint boots to what looks like the FOG imaging menu but then goes away after about 2 seconds. Is there a timeout setting on the FOG server and if so where? Or something on my endpoint side in the BIOS possibly?

Thank you in advance!

After everything setup and configured, clients can’t PXE boot to the FOG server/services. Get a boot error on the device

Here is a screen shot of the error.

Tried a lot of permissions on the Linux server
We setup the DHCP options on the Windows DHCP server.

Hopefully someone can point out something quick and easy that I missed.