That did the trick. Thank you. Was so use to seeing installation finished that it was finished. But did realize it seemed to grab the kernels and client wayyy faster than normal. I’ll make sure to keep that in mind next time.

Ok, I’ll do that. I’ll let you know. Thanks!

I just did an SVN up to update things before making an image. After the computer grabs an IP through PXE it gets to the bzImage deal and then reboots. I tried it on another machine to make sure it wasn’t just the computer but did the same on the other machine too. Just a heads up.

I set up on the server side to perform an upload task. Booted up the client machine and it hangs on the FOG screen. I thought maybe there were some sort of permission issues to the /image folder so changed the permissions but that didn’t do anything.

Getting SOOOOO close! So on the client machine it’s went through some of the load up process within the iPXE. It hangs up at the FOG ASCII screen though with a blinking cursor.
I could always start fresh again if I need to.

You guys are being tricksters now I see! I set everything up and got the image info set and ready to go. Turn on the computer I want to image and nothing. Didnt even find anything. I was so use to just click enter enter enter enter during Fog install that now you have DHCP set to y/N instead of Y/n. Haha. Rerunning this so I have the DHCP service and will let you know if that other issue goes away.

Ok so I figured with this since I been going ham on the previous one I’d start fresh. Im on a fresh install of CentOS, did all of the updates and such. Went to the link and started setting up/installing everything. Even got BTSync up and working I believe :).

I start the install of Fog and towards the end of the install I get this.
[CODE] Press [Enter] key when database is updated/installed.

• Setting up storage…OK
• Setting up and starting NFS Server… * Configuring Fresh Clam…mkdir: can not create directory ‘/opt/fog/clamav’: No such file or directory
  chmod: cannot access ‘/opt/fog/clamav’: No such file or directory
  Failed!
  [/CODE]

Alright sounds good. I’ll give that a try. Thank you for your help. I’ll let you know when I’m done.

Well I don’t need the bleeding edge release or anything. I’m just wondering why I’m getting the “Could not start download: Operation not supported” on the client machine I want to image. If the bleed edge server fixes that I’ll do this right now

Alright, I’ll give that a shot.