Boot menu not loading
I setup a new installation of Fog :
After setup the server, I try to boot and the boot menu doesn’t appear. The worksation receive an ip from the DHCP, try to load the IPXE but reboot just after it.
The only thing that appear is :
IPXE … -Open source Network boot Firmware …
I had to change the ip of the server, perhaps it’s link.
Any help is welcome
just found my error …
I add my DHCP entry to undionly.pxe instead of undionly.kpxe
thanks for your support and your great work.
What is the output of sestatus?
Yes both of them are disabled
Did you turn off SELinux and firewall?
Is the FOG Server’s NIC bridged or NAT’d?
Thanks for your quick answer, the server is setup on a Vmware infrastructure and i use a test VM to boot on PXE … no switch between.
To be sure it’s not an issue with the test VM I also use a physical desktop with same issue. (The switch where the desktop is connected allow Spanning tree)
The switches that these systems are connected to, are they setup for Spanning Tree Protocol? If so, are they setup to allow Fast (e.g. PortFast,Rapid STP,etc…)?