SOLVED Dell Latitude 5510 No network interface found! Kernel might not have the correct driver!
i was using the onboard network adapter and it didnt work
I’m curious to why the onboard adapter to why that didn’t work. I might understand about the USB-C nic not working. On the Dells you need to go into the firmware (if uefi) and enable the uefi network stack on the network adapter page to enable pxe booting. In the case of a usb-c network adapter I can tell you the WD-15 and WD-19 docks support pxe booting with FOG. I believe the Dell usb-c to ethernet dongle also works with FOG.
Just to be clear this is the model computer we are talking about? https://www.dell.com/aw/business/p/precision-m5510-workstation/pd
@Sebastian-Roth i dont have trouble with any other machines only this ones every other machine works fine.
@george1421 ill try that tomorrow at work and i was using the onboard network adapter and it didnt work, but i used a usb c network adapter and it did work. The laptop is a Dell Latitude 5510 its a brand new laptop and i have a few that are going to come in later during the month.
This is a strange situation. If that is the 5510 Precision workstation it should be a similar platform to the 3510 laptops we have. If so those laptops are 3-4 years old, the FOS Linux kernel for FOG 1.5.9 should have the proper driver in it.
What I want you to do is setup a new deploy task, but before you hit the schedule button tick the debug checkbox, then schedule the task.
PXE boot the target computer and after a few screens of text that you need to clear with the enter key you will be dropped to the FOS Linux command prompt on the target computer. At the FOS Linux command prompt key in the following commands, please take a clear picture of the results and post them here.
ip addr show
lspci -nn |grep -i net
The last question is, are you using the onboard network adapter to pxe boot or a usb based network adapter?
@asbenavides Do other machines on that exact same network port PXE boot just fine?