Surface Go Imaging
In the fog ipxe menu can you run a compatibility test?
The error really doesn’t say what’s wrong other than I give up.
I’m going to suspect its having an issue with the hard drive detection.
After the hardware compatibility test, if that still reports successful then lets setup a debug deploy/capture then pxe boot the target computer. After a few key presses it should drop you to a linux command prompt on the target computer.
From the debug console key in
report the results here.
One last thing, what version of FOG are you using? When did you install it? Even with FOG 1.5.4 the devs have patch issues with the kernel and init.xz files to address a few issues prior to releasing FOG 1.5.5. These kernels and inits were updated within the last 2 weeks.