HP Pro 4000 image deploy error
-
I am getting an error when deploying an image to an HP Pro 4000 small from factor, it gives a type of disk partition error, I have changes the bios to disk IDE to see if that would help but still no luck any advice?
-
Have you tried to run a debug mode test on these models in the PXE menu?
Check to see if the NIC / mass storage controller is currently supported in your kernel release.
-
What commands do I run in debug mode? I can boot into debug mode and have a prompt of /#. errors when deploying the image these are the errors. I have attached a screen shot of the process
[url=“/_imported_xf_attachments/0/107_Screen shot 1.PNG?:”]Screen shot 1.PNG[/url][url=“/_imported_xf_attachments/0/108_Screen Shot 2.PNG?:”]Screen Shot 2.PNG[/url]
-
Just to confirm you are [B]PUSHING[/B] the image to the 4000 sff? Is this a standard windows 7 image (100mb partition + ntfs non resizable)
I helped someone on edugeek.net with a similar issue - [url]http://www.edugeek.net/forums/o-s-deployment/61956-fog-client-error-cant-have-partition-outside-disk.html[/url] . Long story short… there was a partition table that couldn’t be read by fog, so wiping the drive allowed it to be imaged.
-
I’ll also point out that if your HP’s have a smaller HDD size / space than your image it can cause this issue - [url]http://www.edugeek.net/forums/o-s-deployment/61445-dell-e6410-fog.html[/url]
-
Yes it is a windows 7 Image taken from another pro4000 from HP, I have tried to wipe the disk but the error is still present. The Image Management is setup to Multiple Partitions Image-Single Disk not resizable. I am going to try to install win 7 and update the bios and see if this helps
[quote=“ssx4life, post: 3282, member: 268”]Just to confirm you are [B]PUSHING[/B] the image to the 4000 sff? Is this a standard windows 7 image (100mb partition + ntfs non resizable)
I helped someone on edugeek.net with a similar issue - [url]http://www.edugeek.net/forums/o-s-deployment/61956-fog-client-error-cant-have-partition-outside-disk.html[/url] . Long story short… there was a partition table that couldn’t be read by fog, so wiping the drive allowed it to be imaged.[/quote]
-
Bios update 2.02 and formatted hard drive to ntfs no partitions and still no luck
-
I just noticed I did not see the pro4000 on the hardware list maybe it is a bios error or sorts Ie not supported?