Hey, I have good news, after disabling secure boot it works ok, and after cloning you can re-enable it without any problem.

Thanks for your help Quazz and George!

Thanks for your answers, I looked for all efi files in my hd but I didn’t found any other than sponly.efi. Following Quazz advice I rerun FOG installer updating it to 1.4.4, after that I get some .efi files, one of them ipxe.efi. But when I try to I get the same as the image attached to my first post. The computer gets ip address, it says it succeeded to download the ipxe.efi file, but after that it starts to check ipv6, and after that it boots from HD instead of the FOG boot image.

Thanks Quazz and George,

According to your replys I founded this article:

https://wiki.fogproject.org/wiki/index.php?title=BIOS_and_UEFI_Co-Existence#Building_custom_DHCP_Classes_for_co-existence_with_FOG

I have a problem here cause I have a Windows 2008 Server as DHCP, and according to this article I can’t configure it to work as DHCP for FOG.

I have a pfsense for testing purposes, I configured it as DHCP according to the following article:

https://wiki.fogproject.org/wiki/index.php?title=Other_DHCP_Configurations

I configured too in UEFI 32 & 64 bits the ixpe.exi file you are mentioning but it still fails.

Then I checked the folder TFTP from FOG installation and the problem is that ixpe.efi isn’t there, Snponly.efi is the only .efi file there, I tried to load it but then it shows a TFTP error when I boot.

Where can I get this ixpe.efi file?

Hi,

I have an issue booting my MIIX 510 I start network booting with F12 and it show the following message:

So it says that is booting correctly but after that it starts to scan for IPv6 and then starts computer from hard drive instead of the network image.

I will add that to start network booting I’m using an USB Ethernet dongle, Thinkpad USB 3.0 Ethernet Adapter (4X90E51405), it seems to work fine cause I’m getting an ip address, finding the network boot server and downloading the image with success.

I will really appreciate your support, thanks!