@george1421
thanks for pointing me in the right direction. I reran the installer with wifi internet and static ethernet and dhcp is working now. I think during the initial install i was trying to use two connection profiles on ethernet, rather than utlizing wifi card for internet to complete install and ethernet for fog only.

@george1421
thanks for pointing me in the right direction. I reran the installer with wifi internet and static ethernet and dhcp is working now. I think during the initial install i was trying to use two connection profiles on ethernet, rather than utlizing wifi card for internet to complete install and ethernet for fog only.

@george1421
thanks for the response george!

-“ps aux|grep dhcp” returns “user 2225 0.0 0.0 14232 1012 pts/1 s+ 09:33 0:00 grep --color=au”

1. connected pc booted to windows does not receive dhcp
2. two, there is also a wireless interface that has not been configured
3. i dont make it to pxe, at “dhcp…” it returns “no dhcp or proxydhcp were received”

Server

• FOG Version: 1.4.0-RC-1
• OS: Ubuntu 16.04 LTS

Client

• Service Version:
• OS: Win 7/10 dual boot MBR

Description

I have successfully setup FOG 1.2 on Ubuntu 14.04 with same hardware, it runs great. I wanted to build a replacement unit with more disk space for use with Windows 10. I did a fresh install of Ubunutu, fresh install of FOG, then followed the wiki to update to trunk. During the setup process I chose to allow FOG to handle DHCP.

I can’t get any PC’s to receive DHCP/PXE at boot. The PC can access the fog homepage fine from a windows web browser with the ethernet port on dhcp.

The server is ethernet method Manual with IP 10.10.10.1, netmask 255.255.255.0 but shows as “24” while editing eth0, gateway 10.10.10.1. dhcpd.conf attached0_1493414395773_dhcpd.conf

The client has network boot enabled in bios.

I have attempted “sudo service isc-dhcp-server start” and “sudo service tftpd-hpa restart” which resolved my fresh install dhcp issues in the past. no luck this time though.