@Quazz @george1421
Thank you both for your answers, appreciate it. I started with the easy solution suggested by Quazz, and it fixed it!
Now running trunk 6677 and the registration just works fine!
Thanks a lot.
Next time I have a problem, I’ll update first, then post on the forum

Hi
Whenever I try a quick or full host registration with a HP EliteDesk 800 G2 Desktop Mini, it fails with the following error:

Attempting to register host…Failed
An error has been detected!
Cannot register host. (/bin/fog.auto.reg)
Args Passed:
Computer will reboot in 1 minute.

I’m getting this on both Fog 1.2 and Trunk 6365.
Other computers are working fine, it seems to be a problem specific to this model (product number: P1G15ET#ABU). Has anyone encountered the same issue or managed to get this model to work with Fog?
I did try and change various BIOS settings to see if that makes a difference but nothing seems to work.

Thanks!

@Tom-Elliott @Arrowhead-IT @george1421 Thanks. I might stop make it work with 1.2 then!
I did try to upgrade to 1.2 and it just broke everything so I reverted back to 1.2
I tried setting up a new server running CentOS 7 and fog trunk but it’s not working either, just getting a blank page when trying to access the console towards the end of the install to set up the DB.
Anyway. I’ll try and set up a trunk version again!
Thanks for your help

hello, i’m having the same issue with a Samsung SM951 PCIe NVMe as Toby777’s post below.
The only thing that works is ‘raw image’, otherwise i’m getting the same error as Toby777.
I tried different init.xz and init_32.xz as suggested in other posts to no avail.
Running Fog 1.2 on CentOS 6. Any ideas? Thanks!

@Toby777 said:

Hi Tom,

Got the Dell tech to replace the motherboard today.

Latest Fog trunk now recognises the nvme SSD.

When the Image is set to Single Disk - Resizable, it hangs at…

* Saving original patition table......................

When Image is set to Multiple Partition Image - Single Disk (Not Resizable), it hangs at…

* Now FOG will attempt to upload the image using Partclone
* Processing Hard Disk: /dev/nvme0n1

When Image is set to Raw Image, it starts the upload…

I’m fine with using Raw Image if that’s what works.