@george1421
You were correct about the hard drive being bad. I replaced the hard drives and they have been imaging perfectly. Thanks for all your help!

@george1421
You were correct about the hard drive being bad. I replaced the hard drives and they have been imaging perfectly. Thanks for all your help!

@george1421

Version 1.2.0
bios system
The hard drive is a known good hard drive. It has an image on it currently that I am trying to replace with a new image

Version 1.2.0
bios system
The hard drive is a known good hard drive. It has an image on it currently that I am trying to replace with a new image.

I am having a problem when I am attempting to image computers. I was imaging 64 Dell OptiPlex 990 desktop computers and all of them except 4 worked correctly. The 4 that didn’t work are causing an issue when I try to image them.

I will register them with the fog server and everything works fine until after I have sent the download task to the host. When the host starts to download the image, the task completes in less than a minute and then shuts down the computer. The computer will not have imaged at all and when I check the image on the fog server the image size: on client changes to 0.0 with the image size: on server stays at 4.01. Once the Image Size: On Client has changed to 0.0 I can no longer use the image on other computers. I have to upload the image back to the fog server again to use it anymore.

1. Is there a setting somewhere that is not allowing the host to image correctly and setting the image size: on client to 0.0?
2. When the image size: on client is changed to 0.0 is there a way to fix the image so that when it happens I do not have to upload a new image again?