[quote=“ch3i, post: 45131, member: 2513”]I use this system.

To do it :
1/ Rsync between the server and laptop to sync database/application and images.
2/ Run the installer on the laptop before each use to update your configuration (pxe, …)

Regards,
Ch3i.[/quote]

Hi Ch3i,

Any chance you could elaborate on what you do as I am trying to set up the same. We run a fog server at head office where we setup all hardware. We then need to travel to remote sites and deploy those images.

Regards,

Shane

Hi Tom,

Using the latest SVN I can’t get into the fog configuration page. All i get in chrome is Version: 3091 and in IE it just errors out and doesn’t display.

Happy to troubleshoot in any way I can but will need guidance.

Shane

UPDATE**

Downloaded Latest SVN (Version 3100) and all is good again.

I just did a deployment on Dell laptops. We changed all of the boot options in the bios to legacy and turned off secure boot. Then we had to boot the master laptop from a windows dvd, go to repair and using the command prompt convert the partition scheme from GPT to MBR. Then install windows, build your image, sysprep, upload. Boot target laptop from Windows dvd,change bios as above, convert partition as above. Deploy image. Worked a treat.

You need to go to fog settings and set a PXE menu master password, then a blank password will work for the quick image.

Also are you trying to do a multicast image? That is the only time I have seen anything about checking queue. If you are you need all the computers turned on and in pxe. Perhaps try a single computer deployment first