Dell Perc s100 Raid Partitions
-
@george1421 But that’s just it, I’m pretty sure linux can install on these systems without an issue.
So about this posting? https://forums.fogproject.org/topic/9333/dell-perc-s100-raid-partitions/9# He states it’s now showing partitions. But what partitions are showing? It’s obviously able to read something now.
-
@Tom-Elliott It would only show the 2 disks as in /dev/sda and /dev/sdb, i am trying a few different bits as i said making the image on hyper-v with the raid drivers and then deploying.
-
I am having getting it to boot when i restore an install from hyper-v, it all goes into the hdd fine and restores ok and the partitions are fine but just doesnt load at all and skips the hard drive.
-
@Tom-Elliott Yes that is correct, just are just controllers and not actually in a RAID. but when i capture it just captures the whole disk without the partitions, i did the same setup on my hyper-v and was able to grab them.
I am going to try another windows install on the physical tomorrow and see what happens then.
-
I have managed to resolve this now, i needed to reinstall Windows on the server and choose New to create the partitions on the installation instead of just next for some reason.
I have now been able to image server 2012r2 and server 2016 without issues.
