Remote Imaging -- Will FOG Work?
-
This post is deleted! -
yes
-
[quote=“Wayne Workman, post: 42363, member: 28155”]I’m going to take a stab at this question. I’ve been using FOG for about 2 months now, it’s working great.
So, you don’t want a storage node at each location because of cost.
My solution to that is to just put a storage node at each location.It doesn’t need to be anything fancy. An old dual-core with a gigabit interface will get the job done just fine. You could even go with an old P4 with Hyper Threading. It’d be slower, but still.[/quote]
It is also possible to install fog on a [URL=‘http://www.raspberrypi.org/’]Raspberry Pi[/URL]. This could be a cheap solution for you. As of now we have only tested and checked that it has installed correctly on a Pi. But the investment is around $50 a Pi and could possibly be a solution for you. The Pi can sit right next to the router and plugin to the same power strip.
Of course we would be willing to help you at every turn.
-
[quote=“Wolfbane8653, post: 42382, member: 3362”]It is also possible to install fog on a [URL=‘http://www.raspberrypi.org/’]Raspberry Pi[/URL]. This could be a cheap solution for you. As of now we have only tested and checked that it has installed correctly on a Pi. But the investment is around $50 a Pi and could possibly be a solution for you. The Pi can sit right next to the router and plugin to the same power strip.
Of course we would be willing to help you at every turn.[/quote]
Now that’s a solution!
I vote for this one.
Clearly, you should just buy 1 at first, and we can get that working and go from there.
-
as much as i like playing with Raspberry Pi’s, i don’t think they’re a good solution to this problem. a refurbished desktop can be had for a little more then the cost of the Pi, and it will have gigabit Ethernet and can take a real hard drive.
-
You could also look into the Banana Pi (has a GIG network on it)
-
And there’s still the “connection” problem. Either you use dyn-DNS and port forwarding (all unencrypted) to connect the FOG servers located at different sites or you go the “long way” of setting up vpn gateways everywhere…
-
This post is deleted! -
Hi, I’ve had this working since 2012. Basically I have 3 Fogservers, the master where I am based, and 2 others, one about 1/2 hour away and the other an hour away. The 3 sites are connected with IPSec tunnel.
I upload an image to the local FOgserver and it replicates slowly across the tunnel to the remote sites. Once transferred, I can \ then create an image task for a remote PC. From there I can run a script on the remote PC which forces it to PXE boot and it gets reimaged.
Maks a couple of customisations and its good to go. HOWEVER, since FOG 1.2 the transfers across the IPSec tunnel have been slower and occasionally stop, which is very frustrating especially since the transfers take over a day to complete! -
How are replication tasks working? Nothing changed directly in how things transfer. The speed or lack of it sounds environmental more than something fog is doing or did.
