Found a work around. Found one old image that works. Thanks for you all help

@george1421 said in BSOD after image with FOG on Optiplex 9010s:

windows just starts

When windows just starts is when the BSOD happens I have tried 3 9010s

@tom-elliott

Also to note I have more then one image on the FOG machine. Every image that I try on the Optiplex 9010 only goes to BSOD.
When I image the Optiplex9020 the image works without a BSOD

@tom-elliott

Thanks I think the image may be corrupted as well. How did it corrupted without any changes is suspicious

@george1421 said in BSOD after image with FOG on Optiplex 9010s:

m

hat version of fog are you using?Running Version 1.4.4
SVN Revision: 6077
What OS are you deploying? win 7
What mode is the target in (uefi or bios/legacy)? bios/legacy
What mode is operating system?bios/legacy
Did you sysprep the system? yes
Is the right drivers installed on the master image yes

PC has been imaging fine until last week

BSOD after image on Optiplex 9010. Happens on every Optiplex 9010 I try and image. Has anyone seen this issue before ?!

What are the proper steps to creating Groups in FOG vie the HOST Tab

@george1421

How do you properly verify if the FOG service is disabled.

@wayne-workman

Yes I did not activate the sysprep application. Once I activated it and recaptured the image. The problem was resolved.

@george1421

Okay found out what the issue was. I did not sysprep the image correctly went back and syspreped the PC used for the image and tried it again. This time it worked after redeploying the image